Intersections: connected or just crossing?

[funkymonk95]

Hey everyone,
I'm in the proces of making this pedal: http://www.diystompboxes.com/pedals/rocket.JPG
I'm kind of a newbie, so don't go too rough on me. My question:
the parts were the first line (9+ voltage, 470 k resistor, 1meg resistor to ground) crosses the line from capacitor 1 to base of transitor 1: are those two connected?
Same with the line from 47 k resistor to 47 uf electrolytic capacitor and the line from the emitter of transistor 3 to 4,7 k trimpot (marked with 'bias')?
And the line from capacitor 4 to capacitor 6 and the line from 1,2 k resistor to 10 k resistor?
Thanks in advance for your answers!

[DC9V]

Welcome to the forum

Yes, all the intersections are connection points.

EDIT: If you're not familiar with them, the different conventions for representing connections between components are shown on this page (just a bit down the page, under "connections"). Your schematic uses the second model.

[funkymonk95]

ok thanks, alot!
That site you gave me will come in handy, I think on a lot of occasions!