Airturn PED Pedal info

CHANGING THE MODE

  1. Turn on the PED.
  2. Press and hold the MODE button. The red
    LED will flash once per second from 1 to 6
    flashes. The number of flashes corresponds
    to the same MODE number. Be sure to count the flashes.
  3. Release the MODE button following the number of flashes that reflects the desired MODE. The blue and red LEDs will flash together the number of times indicating which MODE has been set.

Example: To set MODE 2 hold the MODE button for 2 flashes of the red LED, release and both LEDS will flash 2 times to confirm the MODE 2 setting.

Note: Once the MODE has been set, it will remain the same until it is changed following the above steps.

Reset pairing:

Pairing must be reset whenever switching from one device to another or when switching between MODES 1 and 2.

With the PED powered on, press and hold the power button for six seconds. After two seconds, the PED will appear to power down. Continue to hold the power button. At six seconds both LEDs will blink three times. After the third blink release the power button. The device has been reset. Remove any old pairing from your host computer and then turn on the PED to pair again with the desired host computer.

PAIRING IN PED-APP-DIRECT MODE 1

Note: This MODE is for PED-APP-Direct apps only.

  1. Power on the PED.
  2. Be sure the PED is in MODE 1.
  3. Go to your app and find the Bluetooth setup screen.
  4. Find the PED in the device list and tap on it.
  5. Tap on the Pair option in the dialog box.

PAIRING IN MODE 2-6

Open your computer’s Bluetooth Setup dialog:

iOS – Select Settings>Bluetooth and turn on the Bluetooth if it is off. When the PED is discovered, it will appear in the list of devices. Tap on the selection. A dialog box will then appear. Tap on Pair.

Android – Select Settings>Bluetooth and turn it on if it is off. Make sure your device is set to discoverable. Then tap the SCAN button. When the PED appears, tap to pair.

PC – Select Control Panel, My Bluetooth Devices. Select “Add a device”. Click next and complete pairing.

MAC – Select Apple, System Preferences, Bluetooth and turn on Bluetooth. The PED will appear in the Devices window

Translate »